Until you run the first simulation on your simulation set, the 窶廡ile name窶 field displays just a default file name which was stored in the folder when it was created. You can change this default file name, by using the 窶廡olders窶ｦ窶 command in the 窶弃references窶 submenu of the 窶廡ile窶 menu.
As soon as you run a simulation from this folder, the 窶廡ile name窶 attribute of the folder will change to the file name you specify for your results.
Note that each time you run a simulation, the current file name attribute will appear as the default name in the 窶彜ave as窶ｦ窶 dialog box. In particular when you run the first simulation from a folder, the default file name will be the name specified in the 窶弃references窶.
# runs
The 窶# runs窶 field does not display any attribute. It is just a counter. If you include both the main and the crit. simulation phases in your simulation, the counter will reflect this in the following way: During the first phase, the counter will count the number of finished main simulation runs. After this phase is finished, the counter will be reset to zero. Then, during the second phase, the counter will count the number of finished crit. simulation runs. If you include only one simulation phase, the counter will just count the number of finished runs in this phase.
